rear wiring for liquid-cooled Triumph models from 2016

Do you want to replace the tail light and indicators but do not want to cut the original wiring? With this kit you do not need to cut, extend, connect or re-shear the wires: you get rid off the original wiring and mount this in place, no more than 2 minutes! The change is totally reversible and makes this harness valuable when you go to sell the bike and you will want to bring it back to its original conditions. Ideal for mounting with an undertail or simply to easily change the light and indicators.

Available in two variants:

type A - Street Twin, Speed Twin 900, Street Cup, T100, T120, Thruxton R, Thruxton S, Street Scrambler, Scrambler 900 (2022 +), Speed Twin 1200 (Euro 4 version only)

type B - Bobber 1200, Speedmaster 1200, Scrambler 1200, Thruxton 1200 RS (this version incorporates a resistor to prevent the system warning light from turning on when you mount aftermarket indicators)

type C - Street Twin, Speed Twin 900, Street Cup, T100, T120, Thruxton R, Thruxton S, Street Scrambler, Scrambler 900 (2022 +), Speed Twin 1200 (Euro 4 version only). Longer version for mounting the indicators near the shock absorbers or with lateral license plate holder

type D - Street Twin, Speed Twin 900, Street Cup, T100, T120, Thruxton R, Thruxton S, Street Scrambler, Scrambler 900 (2022 +), Speed Twin 1200 (solo versione Euro 4). This version is intended for motorcycles equipped with two rear lights, e.g. with 3-in-1 indicator + light combinations on both sides of the bike, incorporates a resistor to prevent the system warning light from turning on when fitting aftermarket indicators.

Type E - Speed ​​Twin 1200 (Euro 5 version only)

Fitting the Bullet, Cat Eye and Arizona front indicators without cutting the original wiring, you need to purchase the DDM011 kit